DIY friendship bracelets! 4 Easy Stackable Arm Candy projects!
You will need, any kind of cord and some small beads.
Start off with 3 pieces of cord(50-60 cm long), tape them to your table so they don’t move and start making some square knots. For that take the left cord cross it over the centre and under the right cord and thread this right cord under the centre and through the loop created by the left and centre cords. Then do the same on the other side. Take the right cord cross it over the centre and under the left cord and thread this left cord under the centre and through the loop created by the right and centre cords. Make a bunch of those, take two small beads like these ones and thread them though the side cords. Then make a couple of square knots and repeat as many times as you want. Make some simple square knots like in the beginning to complete the bracelet.
Then, as on my other DIY bracelet videos cut the side cords and secure the last knot with some clear nail polish. To make the closure tape down the two cords and start making some looser square knots with another cord (25cm). To finish the bracelet, thread a bead on each side and tie two little knots to secure the closure. And the first bracelet is finished!
You will need any type of cord in two different colors you want(or just one color too).
Take 3 pieces of cord of each color (50-60cm) and make a regular knot. Then tape it to the table, separate the two colors and make some square knots on each side. Then make two more square knots but this time using all the cords at once, with two cords on the left, two on the middle and two on the right side. Repeat this until you have the length you want. Then make a knot just like in the beginning. Keep one cord of each color on each side and cut the rest as I’m doing here, secure the knot with some nail polish and make the same closure we did with the first bracelet and this super cute bracelet is all done!
You will need, suede rope in three colors and some crimp end closure.
Take two pieces of each color (30 cm) and tape them. To make the braid start with the cord on the left side, cross it over the second cord and under the third one. Now start on the other side, this time cross it first under the second cord and then over the third cord. Finally cross those two cords with each other. Then repeat over and over again until you have the length you want. Once you get there, cut off the excess and add your closure, and that’s it!
For the last one you will need: some cord, some beads and some smaller beads.
Take a piece of cord (40cm) and thread some beads, I started with the small one, then the large one and repeat like so. Then make a knot on each side so they stay in place. You can leave it like so or add some more small beads and tie some more knots like so. Finally make the same closure as for the first two bracelets and that’s it!
Don’t forget to leave me in the comments which kind of videos you want to watch next. Thanks for watching!!
Yorum yapabilmek için buradan üye girişi yapınız.